requirements and precautions for the voltage and power cord in the installation of lawn floor lamps

Apr 08, 2021

Leave a message


The requirements of the lawn lamp voltage is not high in stalling of lawn floor lamps. 180~250 is ok, but the power line must use twisted-pair and more than 2.5 square copper wire, if it is convenient, add an independent electric leakage switch. When pulling the wire, pay attention to the protective pipe wrapped in the outside of the power line should not be exposed. To be buried about 20cm deep. Above all content is only for your reference, special action will depend on geographical environment.


2

Send Inquiry